The NETGEAR WGR614 router is available in 10 different versions, but all of them use password as the default password. As with most passwords, the WGR614 default password is case sensitive.
Every version of the WGR614 router also uses the default username of admin. When asked for the WGR614 password, just enter that.
Although the username and password are the same for each version of this router, the first five versions (1–5) have a default IP address of 192.168.0.1; versions 6 and newer use 192.168.1.1.Netgear
If the Default Password Doesn't Work: Reset the WGR614
If password doesn't work when you log in, the password was changed at some point to something else. Changing the default password of any device, including the WGR614, is an important security practice. The downside is that it's easy to forget. Reset the NETGEAR WGR614 router to restore the username and password to the factory defaults.
Here's how to reset the WGR614 router:
Plug in the power cable and turn on the router.
Turn the WGR614 around to access to the back panel, where the cables are plugged in. Look for the Reset button.
If you don't see the Reset button on the back of the router, check the bottom. Different routers have this button in different places.
Firmly press the Reset button with something small and pointed, such as a paperclip or pencil, for 10 seconds.
Wait for the router to reset. This may take between 30 and 60 seconds.
Unplug the power cable from the router. Then, reattach it after a few seconds to reboot the router.
Wait 30 to 60 seconds for the router to boot up.
The router is now reset. Log in with the default username and password of admin and password. The IP address you use to access the login page will be different depending on the WGR614 version you have.
Resetting the router to its factory defaults resets every customization you made. If you had custom DNS servers, a wireless network, or port forwards, re-enter that information, which might involve configuring the DNS settings again, setting up an SSID and wireless password, and forwarding the ports. Check "Configuration File Management" in the WGR614 router user manual for instructions on backing up router settings.
When You Can't Access the WGR614 Router
If the default IP address for your WGR614 doesn't give you access to the router, it most likely means that it was changed at some point. To find the correct IP address, you want to locate the default gateway IP using any device that's connected to the router.
When you reset the WGR614, the default password is reinstated, too, not just the password. If you followed the steps above to reset the router, access the router with the default IP address. You shouldn't need to find the default gateway.
NETGEAR WGR614 Firmware and Manual Links
Every resource NETGEAR has on the WGR614 router is available on the WGR614 Support page.
If you need the support page for a different version of this router, pick the right version from the Select a different version dropdown menu on that page.
No matter which version of the WGR614 you use, download the most recent firmware in the Downloads section.
When downloading firmware from the NETGEAR website, select the one that corresponds to the same hardware version of your WGR614. Installing the wrong firmware can cause problems with the router functionality.
Here are direct links to the WGR614 manual for each version of this router:Version 1Version 2Version 3Version 4 Version 5Version 6Version 7Version 8Version 9Version 10
These NETGEAR WGR614 user manuals are in the PDF format, so you'll need a PDF reader to open them. The WGR614v4 manual is also a PDF, but it's stored in a ZIP file.